Halloween - Featured Designer Challenge by Jaimie Ramsey

Supplies:
Scissors
Acetate
Double sided tape
Black ribbon
Orange patterned paper
black patterned paper
American Crafts thickers
Tim Holtz distress ink in "rusty hinge"
foam tape
Scallop punch
1 3/8" circle punch
Martha Stewart double sided edge punch "infinite loops"

Step 1
Cut a piece of acetate 7” x 7” square

Place double sided tape on one edge

Roll to adhere 7 form a tube – see picture #1 

Step 2

Using the Martha Stewart double edge punch “infinite loops”, punch a strip of orange patterned paper long enough to go around the acetate tube

See picture #2

Step 3

Cut two pieces of 7” by 4” orange patterned paper

Run double sided tape along one long edge & one short edge of each piece

Adhere to the ends of the tube – see picture #3 

Step 4

Using scissors cut strips in both ends of the orange patterned paper – see picture #4  

Step 5

Cut a piece of black patterned paper just a bit larger than the punched piece of orange patterned paper you created in step 2

Adhere the black paper under the orange for contrast – see picture #5 

Step 6

Adhere the piece around the middle of the tube – see picture #6

Step 7

Punch a scallop out of the orange patterned paper

Punch a circle out of the black patterned paper

Adhere the black circle on top of the orange with foam tape

Using Tim Holtz distress ink in “rusty hinge” ink some white American crafts thicker letter stickers to match the patterned paper

Adhere them to the black circle

Then adhere the piece to the middle of the tube – see picture #7 

Step 8

Using the black ribbon, tie a bow around one end of the tube, where the fringe of cut strips ends

Using your fingers, splay the fringe for effect

See picture #8.   Fill with your favorite treats!